Aging wood floors will lose their luster with usage. The finish wears away, the blot discolors and small regions of damage seem, with scratches or gouges stand outside and marring the look of the ground. Surface damage of this sort can make the whole room seem worn. Rather than replacing the timber or covering it with carpet or tile, it is possible to restore the luster of your flooring. Fixing the small damaged areas and then eliminating the worn finish to replace it with a new coating can completely alter the look of the ground. After completion of the restoration project the timber may look as great as it did when first installed, providing a bright, long-lasting finish that adds to the overall look of the room.

Eliminate all of the furniture in the room. Remove the baseboard surrounding the ground by placing a prybar between the boards and the wall in the points where the boards secured with nails. Apply pressure to the prybar to pull on the board away from the walls, working down the board length till you’ve removed it completely.

Press on any nails into the floorboards, using a nailset. Wash the surface of the floor with a slightly damp mop, with a mix comprising 1/2-cup vinegar blended with 1 gallon of water. Allow the floor to dry thoroughly, for about 2 hours, prior to continuing.

Analyze the ground for any heavy gouges or small holes. Fill out the spaces with wood putty, packaging the regions completely with a putty knife. Scrape the surface of the patch together with the edge of the knife to level it out together with the surrounding surface. Allow the putty to dry immediately.

Put a 36-grit sanding pad onto the drum sander and run the barbell across the whole length of the ground, starting in a corner of the room. Function in rows in addition to the grain of the timber, overlapping each pass by 2 to 3 inches to avoid leaving clear sanding marks. Deal with difficult to reach places, like edges and corners, with a floor edger. Perform 3 more sanding runs to completely remove the finish, shifting sanding pads each time, moving upwards through a 60-grit mat, an 80-grit pad, and completing with a 120-grit flooring buffer screen. Sweep away any sanding debris after each sanding jog.

Wipe the ground surface with a cloth dampened with mineral spirits to remove any dusting residue.

Apply a coating of wood stain to the ground to improve the colour of the timber. Choose between an oil-based or water-based stain. Water-based stains dry more quickly, but oil-based stains provide deeper colors. Brush on the blot with a large paintbrush, working together with the wood grain from a wall of the room to the entrance of the room. Apply a good coating of stain, taking care to not pool it in place and making sure you’re having an even coating. Work in small sections, employing the stain and then going over the area with a foam applicator to remove signs of brush marks. Wait for 24 hours after the program for the stain to dry. Inspect the floorboards, and use a second coating of stain if you desire more depth of colour.

Safeguard the surface and put in a glossy luster by applying a coating of foam finish into the stained flooring. Distribute the foam layer round the floorboards using a low-nap paint roller. Work the roller across the ground in a back-and-forth motion, spreading the urethane evenly. Overlap the roller rows to stop line creation. After application, wait 3 days for your water-based finishes to dry7 days for oil-based finishes, before using the ground .

Reattach the baseboards surrounding the ground, nailing down them into place. Return the furnishings to the room.

See related