Poulan Pro chain saws have two-cycle engines that help make them efficient in cutting Tree Trimming & removal Bakersfield Planting Redding activity Fort Lauderdale limbs and firewood in your lawn (Salt Lake City, UT) (Salt Lake City, UT). While these chain saws come with a one-year warranty to guarantee operation, you may occasionally encounter issues that prevent your saw from functioning correctly. Whether the saw won’t start or does not cut properly, you may have the ability to troubleshoot the problem yourself without calling Poulan for assistance, and that means that you may return to your yardwork as quickly as possible. Leaving your repairs with manufacturer recommended components won’t void your warranty, but you must maintain your chain saw based on recommendations in the owner’s manual to obtain the complete value.

Check the Fuel

In case your Poulan chain saw won’t start, the very first thing to examine is the fuel. Always use a fuel mix composed of 1 gallon new unleaded petrol and 3.2 oz of Poulan 2-cycle air-cooled motor oil, to attain the recommended 40:1 fuel-to-oil ratio. When you mix the fuel and oil, date the container so you know you are never employing a mixture that’s more than 90 days old. If your fuel is new and you smell gas when you try to start your chainsaw, the motor is probably flooded. Allow the saw sit for about 15 to 20 minutes — if the flooding is mild, the fuel must disappear so you can finally start the chain saw. If the flooding is much more intense, turn the cum off and turn on the fast idle. Then turn the saw, hold it firmly and drag the start rope in short, energetic pulls till it begins. If it doesn’t start within 15 pulls, then the spark plug is probably wet-fouled. Eliminate it and check for moisture on the electrode. If it’s wet, it ought to be replaced. Turn the saw so the engine is upside down, and permit the extra fuel to drain away prior to replacing the spark plugin to

Check the Filters

Your Poulan chain saw may fail to start if its filters are dirty. Start by checking the air filter — remove the filter from beneath the cylinder cover and clean it with warm, soapy water. Rinse it with cool water, and allow it to dry thoroughly before reinstalling. To prevent future issues, clean the filter after every five hours of surgery or 10 tanks of fuel, whichever happens first. An air filter may not be fully cleaned, however, so replace it after every 50 hours of usage or yearly, whichever happens first. A dirty or worn fuel filter may also prevent the chain saw from starting. Poulan recommends replacing your fuel filter annually. To replace, then drain your chain saw of fuel and remove the fuel cap. Pull the filter out of in the tank and disconnect it from the end of the fuel line. Replace with a new filter, and reassemble

Check the Carburetor

In warm weather, then your Poulan chain saw may fail to start after sitting for 15 to 30 minutes since the carburetor has become vapor locked. This happens when warm gas disappears in the carburetor and stops the right quantity of fuel from reaching it. To fix the problem, flip the saw its side and carefully loosen its gasoline cap to release any pressure inside the tank. Replace the gas cap, and thrust the primer bulb a couple of times till it fills with fuel. The saw must start immediately, but if the bulb does not fill with fuel, allow the tool sit for a half hour before attempting to start it.

Check the Chain

In case your Poulan chain saw begins but does not cut correctly, there may be an issue with the chain. First, check to find out if the chain is moving. If it is not, cut the motor and see if the chain brake is engaged. The brake can engage mechanically from a sudden movement. If the brake is disengaged but the chain still does not turn, turn the saw off and examine the drive links for burs that might bind the chain. Analyze the string’s bar to find out if there is a pinch that’s preventing the chain from death through it freely. If the chain is moving but still not cutting correctly, it has probably been dulled by accidental contact with dirt. Poulan recommends taking your saw to your professional chain sharpener for sharpening when needed.

Leave a Reply

Your email address will not be published. Required fields are marked *