Honda manufactured riding lawn for example in Salt Lake City (Salt Lake City, UT) mowers from around 1979 through around 1999. A number of these mowers, such as versions H2013SDA and H2013HDA are equipped with a blade belt adjustment mechanism for memorizing a brand new belt after installation. If you notice the Lawn Care service Bakersfield, CA Care price Littleton isn’t discharging properly out of your mower’s deck, then the buckle could be wornout. Honda recommends replacing stretched or worn belts — they shouldn’t be tightened using the adjustment mechanism. Prior to adjust a new belt, the mower deck should be leveled front-to-back and side-to-side so the deck wheels are not touching the Landscaping price Fresno ideas Long Beach, CA and you get the appropriate pressure on the belt.

Park your Honda mower to a level area. Lower the deck to the number 1 place. Turn off the engine; set the parking brake, and pull on the spark plug wire off the spark plug.

Push the power take off, or PTO, lever to the on position. Inspect the blade belt to make sure it is properly installed on all the pulleys and within every belt guard.

Find the belt tensioner arm to the mower deck. It’s a bracket-like, flat piece of steel that falls at the center where the tension arm runs across it. The pressure arm places pressure on the PTO clutch arm, which holds the belt beneath pressure when engaged. The PTO connecting rod is inserted at one end of this belt tensioner arm, at the other end are three bolts — the middle bolt is a thrust bolt, and the two outer bolts are adjusting bolts for tightening the belt.

Loosen both adjusting bolts on the belt tensioner arm only to this stage the tensioner arm is free to move. Don’t remove the adjusting bolts from the belt tensioner arm.

Move the belt tensioner arm so the PTO connecting rod is making contact with the forward side of this hole at the PTO arm and the forward side of this hole at the belt tensioner arm. Tighten both alteration bolts securely while holding the rod in position.

Place one hand on the belt. Use your other hand to set the belt tension by pushing the PTO connecting rod forward before the belt is snug on the pulleys.

Leave a Reply

Your email address will not be published. Required fields are marked *