Fence painting is designed to achieve two things. It’s a way of giving your fence a more attractive look, and is also a maintenance strategy that protects various components of the fence from bad weather. However, for most homeowners, the idea of painting their fence might look time-consuming. They don’t know where to start or how to do it. But it’s not that hard, especially if you follow a few tips.

Here are some of the tips you should keep in mind when painting your Glendale fencing:

Supplies

You will need a few supplies before you begin painting. This include a wide polyester or nylon brush, a paint sprayer, a paint roller, fence paint and coating, a face mask, a wire brush, a plastic drop cloth, some disposable gloves,  newsprint, and masking tape. These supplies can easily be sourced from your local hardware store.

Once the supplies are gathered, it’s time to start painting the fence.

Follow the following simple steps:

Remove the Old Coating

The reason why you are painting your fence is because the old coating is no longer good enough. So, there’s no need to paint over it. Get rid of the old coating by scrubbing it. Even Glendale fence that haven’t been painted before will require some scrubbing in order to smooth out the surface. This makes it easier for you to apply the coat, and will also ensure that the paint holds.

Prepare the Surface

Once you have stripped off the old coat you must rinse it off with water. A high-pressure nozzle will be very helpful. If you decide to use a pressure washer, make sure the pressure is not too much for the wood, because it might create lap marks that will affect your paint.

Clean the Fence

Once the debris from the old coat is rinsed off you will need to clean up the fence before applying the new coat. A small amount of bleach water solution will be needed. Use a dry cloth to wipe off every inch of the fence while gently scrubbing with a bristle brush. Once the fence is clean, give it a few minutes to dry up. Sand away any visible imperfections as the water dries off.

Start Painting

Before you start painting, make sure that your lawn (Salt Lake City, UT) and Grass Care service Phoenix are protected from any potential spill over. Wear some protective gear too. Put the paint in a bucket and mix it thoroughly. Dip the brush into the mixture and start applying the coat. Start at the top and move horizontally until you are done. For the best results, you might need to apply two or three coats. This will take time but don’t rush it.

Painting your Glendale fence is not hard. With the right supplies, the right guide, and enough free time, you will be able to get the job done easily. The simple guide above should help you a lot.